Using a 2.5” ribbon measure an 8” tail and pinch together.

Measure a 7” loop, pinch, twist, and make another loop.

Repeat the previous step with each of the 2.5” ribbons and make a loop on each side slightly smaller than each of the previous layers.

Dovetail the ends of ribbons.

Using 3- 1.5” ribbon together, pull together and dovetail the ends.

Measure a 8” tail and pinch together.

Add the ribbons into the EZ Bow Maker.

Measure a 5.5” loop, pinch, twist and make another loop.

Cut ends into dovetails.

Repeat previous steps, measuring an 8” tail and loops slightly smaller than the previous layer.

Using the last 1.5” ribbon measure an 8” tail and pinch together.

Measure a single loop slightly smaller than the previous layer, pinch, and twist.

Dovetail the ends of ribbons.

Take 2 pipe cleaners and twist them together, then wrap around the center of the bow.

Put the pipe cleaner in between the pointer and middle finger that is holding the bow, grab the pipe cleaner, and pull.

Start twisting the bow until it is nice and tight.

Tie bow to the fluff box to fluff out your bow.

Pull apart the loops and tails layer by layer.