Start with a wooden tag base.

Paint your wooden tag using a sponge brush.

Dry your paint using a heat gun.

Paint mod podge over the paint layer on the area you want to add your tissue paper using another sponge brush.

Dry your mod podge using a heat gun.

Add tissue paper over the mod podge area.

Add a parchment paper over the tissue paper and melt the tissue paper to the mod podge area using an iron.

Cut off the excess pieces.

Sand off the edges using a sanding block.

Start with downloading your design.

Prep your cricut machine.

Open the cricut software and start with a blank page.

Upload your design to the blank page.

Measure your shirt space and make sure your sizes for the design are correct.

Feed your smart vinyl to the cricut machine.

Print your design.

Weed your design.

Take contact paper and add it to the smart vinyl of your design.

Remove the design from the vinyl using the contact paper and add it to the wooden tag.

Remove the contact paper.

Take 1 ribbon and work it through the wooden tag hole to make a hangar.

Make a bow by cutting 6 pieces of ribbon and using another ribbon piece to tie them together.

Add the bow to the base of the hangar.

Dovetail the ends.

Fluff out your bow.

Take 1 ribbon and cut a piece, adding it to the top of the tissue paper.

Use paint to make small dots on the design using the end of your sponge brush.

Use a heat gun carefully to dry the paint.