Start with a wire wreath form.

Take a 21” mesh roll, bunch the end and add it into a twist tie and make 10” poofs all around your wreath on the inside ring.

Take a 10” mesh and cut 10 x 30” pieces.

Take the 30” mesh pieces and make cruffles by curling the edges in and pinching the middle together.

Add the 8 x 30” cruffles into the outer ring of your wreath.

Add the remaining 2 x 30” pieces to the inner ring.

Add 20” pieces to the other inner twist ties.

Add cable mounts to the back of the sign.

Add pipe cleaners into the cable mounts.

Secure your sign to the middle top of your wreath.

Take 1 ribbon and cut a 32” piece.

Make it into a circle with a little overlap.

With your next ribbon make it 4 inches shorter and do the same thing.

Take your last ribbon and cut a 12” piece just for the middle loop.

Take your first circle, ruffle the middle together.

Take your next one, ruffle it and add it on top.

Take your middle loop and add it into the middle

Secure your bow together with a pipe cleaner.

Cut a strip of each ribbon for tails and add that to the bow.

Dovetail the ends.

Add your bow to the bottom of your sign and secure it with pipe cleaners.

Fluff out your bow.

Take your 4” ribbon and cut 10x 14” tails.

Dovetail the ends.

Take your next ribbon and cut 10 x 13” tails.

Dovetail the ends.

Take your next ribbon and cut 10 x 12” tails.

Dovetail the ends.

Layer the 3 tails and add them into the ties.

Add in some greenery.

Take some gold leaves and add them into the design.