Add styrofoam square blocks to a caldron with hot glue
Using hot glue add giant craft stick to the back of sign, let dry
Add about 15” of garland to the base with u-pins that have been dipped in hot glue, bend pine tines down
Using 10” mesh cut at 10”, curl in both sides, put on u-pin over the center, add hot glue and add into base x3 pieces
Cut a small piece of the garland to add into the center of the mesh, fluff out
Add sign towards the back of caldron with hot glue
Add about 15” of a leaf garland around the base of the caldron under the black garland
Trim bead spray into 3 pieces, cutting them at an angle, curve the slightly, add into base
Make a bow starting with 2-½” ribbon, 2 loops and 1 tail
With 1” ribbon, make 1 loop and 1 tail, tie with a pipe cleaner, dovetail ends
Use u-pin to make a bow pick and add with hot glue
Make a small bow by cutting small strips of ribbon, dovetailing the ends and layer on top of each other
Pinch in the middle, add a pipe cleaner and add to the tip of sign
Trim three floral stems into 3 pieces each and add to base in triangle method
Optional: add a piece of felt to the back of the sign