• Project #1 - Lantern Swag
• Using one small floral filler spray, fluff out and rotate some of the leaves down
• Using a 1-½” ribbon, make a 10” tail, pinch, make a 7” loop, pinch, twist and make two more loops, trim off
• Tie together with pipe cleaner, trim off excess and attach to spray
• Fluff the bow around the spray
• Using a zip tie to attach spray to lantern top
• Optional: Add a 10” piece of deco mesh attached to the back of spray

Project #2 - Milk Jug

• Add styrofoam into the jug
• Cut the greenery spray into pieces and cut at an angle
• Start adding into the center of the jug, fluff and separate leaves
• Then use the triangle method to continue adding pieces
• Working in layers, cut the next greenery at angle and add in between the first layer
• Separate the foam leaves, cut at an angle, continue in triangle filling in empty spaces
• Use floral pick, fluff out, pull apart into smaller pieces
• Add pumpkin offset from the center
• Add other pieces around the pumpkin;  add floral pick for height when needed
• Add some berries and leaves in empty spaces
• Final touch, add airy branches

Project #3 - Centerpiece

• Using a piece of garland, fluff out branches
• Use a floral spray, fluff out, add to one of the ends by twisting the pine tines
• Add second piece and add to opposite end
• Pull pieces upward so all are not laying down
• Layer another piece of pick garland and fasten with pine tines
• Spread out the picks
• Using 2-½” ribbon 10” tails, make three 7” loops
• Next layer 1-½” ribbon layer on top
• Make center loop, tie off with pipe cleaner and add a zip tie
• Fluff loops and add bow in center of project
• Spread loops and work in some of the other layers up through the bow
• Dove tail the ends
• Make ribbon tails by layering both ribbons together, pinch and attach with a pipe cleaner
• Tie tail into project, make a roller coaster loop, pinch, and attach to garland, cut off ends
• Spread out loops and tails
• Repeat steps 13-15 on opposite side

Project #4 - Another Lantern Swag

• Using leftover tip from garland, fluff out
• Add leftover piece of pick garland on top of garland
• Make bow with 10” tail, pinch, make 7” loops x3 (see project #1)
• Fasten with pipe cleaner, fluff loops, pull the pick berries through the bow
• Dovetail the ends
• Add a piece of 10” mesh behind the bow before adding to the lantern