Prep the Base
Add 12 tinsel ties to the pancake frame
Using 21” mesh begin add end of mesh into the first tie
Make 10” pouf on the inside holes
Form the pouf before adding into twist by making sure edges are turned under
When you get back to the first tie, undo it and all the mesh and cut
Put end of mesh into the twist tie and continue with 13” poufs around the base, cut end
Using 10” mesh at 25” strips x12
Curl in one end and scrunch up the center and roll the other end toward you, add into the twist tie
Cut 14” ribbon tails with 3 ribbons; 2-½” & two 1-½” ribbons; dovetail and group together, fold in half
Pinch ribbons in the center and add them to bottom row into each twist ties
Fluff ribbons out, alternating the tails
Repeat steps 9-11 for the top row
Decide where you want the sign
Cut small pieces of cardboard or felt to put under pipe cleaners before stapling to sign
Attach sign to wreath base
Make the Bow
Using a 4” ribbon, make approximately 7” loop, pinch, twist, make another loop and cut tail (about 8”)
Using a 2-½” ribbon make 6-½” loop x4 with tails
Using a 2-½ ribbon make 6 “ loop x2 with tails
Using a 1-½” ribbon make a 4” loop only with tails
Tie together with a pipe cleaner
Fluff loops and dovetail ends
Add to wreath below the sign
Add Florals and Greenery
Cut floral and greenery pieces off the stems
Add one greenery piece into each of the twist ties with hot glue
Add one floral piece into each of the twist ties with hot glue either on top or underneath the greenery pieces
Add flower bloom pieces
Decide where you want the flower blooms, then add them with hot glue
Add one bloom above the center of the bow
Add another floral greenery stem and add under each of the flower blooms with hot glue