Go Back
Print

Baby Shower Wreath

Materials

  • 1 unit wreath
  • 1 rolls mesh
  • 2 rolls ribbon
  • 2 pieces two pipe cleaners
  • 1 package Attach Stars
  • 1 unit Attach Sign
  • 1 pack bbq skewers
  • 1 bunch Floral Stems
  • 1 package Ball Ornaments
  • 1 package pine tine attachment

Instructions

Cut and add Mesh

  • Cut your mesh into strips
  • Gather your mesh and attach it to each pine tine attachment place
  • Make your wreath form nice and full. You should be able to see your wire

Cut Ribbon Tails

  • Cut 18 using your ribbon board to measure and cut
  • Use two different ribbons

Attach Ribbon Tails

  • Place your smaller width ribbon on top of your larger one. Then pinch in the middle and attach to your pine tine attachment. Placing ribbon tails on every single one.

Make Bow and Attach

  • Take two pipe cleaners and twist tie them together.
  • Make your tails 7 inches
  • Make your loops 7 inches
  • Bring in a second ribbon and repeat the same steps but bringing the tails and loops a little bit smaller.
  • Keep layering your ribbon with coordinating ribbon bringing each loop in a little each time.
  • Secure with your pipe cleaner
  • Dovetail your ribbon tails

Make and Attach Stars

  • Hot glue stars to bbq skewers

Attach Sign

  • Attach a piece of ribbon to the back of sign and attach a pipe cleaner through the ribbon. Use this as your point of attachment.

 Attach Floral Stems

  • Dipping your stems into hot glue and pushing them into your mesh. Adding in a triangle method.

Attach Ball Ornaments

  • Dipping in hot glue and placing them in empty spaces.