Using 3- 2.5” ribbon together, pull together and dovetail the ends.

Measure a 9” tail and pinch together.

Add the ribbons into the EZ Bow Maker.

Measure a 7” loop, pinch, twist and make another loop.

Using 2- 2.5 ribbon together, pull together and dovetail the ends.

Measure a 7” tail and pinch together.

Measure a 6.5” loop, pinch, twist and make another loop.

Keep tails at the same length.

Repeat steps to make another loop on each side.

You are going to have a total of 7 loops on each side.

Using a 1.5” ribbon, measure a 7” tail and make a loop on each side slightly smaller than the previous layer.

Repeat the previous step with each of the remaining 1.5” ribbons.

Take 2 pipe cleaners and twist them together, then wrap around the center of the bow.

Put the pipe cleaner in between the pointer and middle finger that is holding the bow, grab the pipe cleaner, and pull.

Start twisting the bow until it is nice and tight.

Tie bow to the fluff box to fluff out your bow.

Pull apart the loops and tails layer by layer.