Deco Mesh Valentine's Day Wreath

Push all the twist ties on the wreath form upward so they are ready for you to add the deco mesh.
Lay your 21″ deco mesh on the floor below your workspace so you can unravel easily as you measure and create poofs throughout the wreath.
Make sure to fluff as you go.
Once the you’re done with this top layer, find the nearest twist and tie off the deco mesh.
You can keep going around on creating poofs on the bottom row of twist ties.
Open up the first one twist tie and secure the end of your deco mesh. Get it nice and tight.
Now, you can cut the tail.

Take your 20″ cut deco mesh pieces and curl each piece inward at each end. Then crunch them towards the middle. *Pro-tip: this keeps the cut edges hidden as they tend to fray.
Now add these ruffles all around the base.

Using the ribbon tail board, wrap the 2.5″ inch ribbon around the 14″ section 5 times.
Pull the wrap off of the board and cut each end. This should give you 10 ribbon tails once it’s cut.
Keep each side together (5 per side) and fold in half length-wise to cut diagonally from non-wired side to wired. Repeat with the other set of 5.
Repeat step 1-3 with 1.5″ ribbon, except in this wreath we wrapped it 18 times to create 36 dove tails.
Layer (2) 1.5″ ribbon tails over (1) 2.5″ ribbon tail and fold them in half to crease.
Crunch the ribbon together at that crease and add to twist ties on base.

Using your 4″ ribbon, measure out 8″. Pinch it in the center. We’re going to give it a twist, slide it in. We want our pretty side up.
For this process we’re going to have two loops and two tails.
Using 2.5″ ribbon repeat step #1 with a 1/2″ inch shorter loop, but leave your tail the same length as the previous layer.
Repeat with this layering process with the smaller size ribbon on each layer.
Remove the bow from the EZ Bow Maker and secure with a pipe cleaner.
Repeat 2 more times so you have 3 bows in total.
Add the bow to wreath with the pipe cleaners that holding the bows together. (Top, bottom, and side)