Weed your image out using an exco knife
Pull down your vinyl and get it as close to the surface and slowly peel it
Do not throw it away the vinyl you peels off until the project is finished just incase you forgot a dot to an I
Now time to weed the image. Grab the middle parts of the letters that didn’t come out
Cut contact paper down to size
Check to make sure it fits over image, always check twice and cut once
Taking your exco knife puncture the corner so you can raise it off the contact sheet
Turn image vertically
Fold your vinyl like a taco
Go right over top of image in the middle and place
Then roll it out on each side
Using a scraper tool go over top and brunish it. (Rub air out of letters so they stick to sheet)
Use spatula and take sheet off mat
Now place letters face down
Take a corner and turn it and get it started, roll it as close as you can get it and start unrolling it. If you see a letter didn't not get off the white then lay it back down and rub it back on with finger and try again.
Must keep it flush with surface
Now your image is on transfer sheet