Fluff the evergreen base
Begin with 21” deco mesh, make 10” poufs on the inside ring x8; fluff the poufs
Add in the fall leaf garland tying into the pine tines just under the poufs
Using 30” cruffles, add into the outer ring of the base under the leaves
Continue adding cruffles until base is full
Squeeze the base together to make slightly oval
Decide where you want to put the pumpkins
Prep the pumpkins by placing three points of contact by sticking in u-pins
Add pipe cleaners to pins and hot glue; repeat on the second pumpkin
Add pumpkins to wreath after hot glue has dried by running pipe cleaners through the mesh, add more hot glue to base of pumpkins
Make a Hand Bow
Build from top to bottom
Using 1-½” ribbon, make a 8” tail down, and make two 13” loops, 8” tail up, cut
Using 1-½” ribbon, make a 8” tail down, and make two12” loops, 8” tail up, cut
Using 1-½” ribbon, make a 8” tail down and make two 12” loops, 8” tail up, cut
Using 2-½” ribbon, make a 8” tail down and make two 13” loops, 8” tail up, cut
Using 2-½” ribbon, make a 8” tail down and make two 13” loops, 8” tail up, cut
Attach layers with a zip tie and add a pipe cleaner before cinching closed
Add bow to wreath with pipe cleaners and fluff and dovetail ends
Add tails to the bottom and throughout the wreath base
Finishing Touches
Cut sprays, picks, florals, and leaves off the stems
Add the pieces throughout the wreath using hot glue
Make a half bow, starting with 1-½” ribbons, making 1 loop and 2 tails with each ribbons
Continue with the 2-½” ribbons
Each layer should be slightly larger loop than the one before
Attach the layers with a zip tie, adding a pipe cleaner before cinching closed
Attach half bow to wreath with pipe cleaner through the mesh
Fluff the bow and dovetail the ends
Add a few florals or leaves in the bow