Start with an 18” evergreen wreath frame.

Fluff out your pine needles.

Take a 10” roll of mesh, take the end of it, make an 8-10” poof and secure it into a pine needle.

Take the mesh and keep making poofs along the upper ring.

After the inside ring, make poofs along the outside ring making them slightly bigger.

Take a different mesh and cut 20” pieces.

Make a ruffle by pinching the middles together and add it into a pine needle.

Add a piece of mesh into every second pine needle tie.

Take 2 x 12” pipe cleaners and secure them together to make 1 long pipe cleaner.

Using different ribbons, make 6 bows.

The first bow will have a 7” loop either side and 12” tails. Every bow after that will have slightly smaller loops.

Add your bow into your pipe cleaner and twist it, as you make them layer them on top.

Secure your bow together with a pipe cleaner.

Flip your stack over and tighten your pipe cleaner.

Fluff out your bow.

Dovetail your ends.

Attach your bow to the wreath using the pipe cleaner.

Cut some 7” tails and add them into your wreath.

Make some funky bows with 1 loop and add a few around the edges of your wreath.

Take your sign and attach a cable mount to the back. Let dry.

Add a pipe cleaner into the mount and attach it into your wreath.

Add in some purple flowers.

Add in some greenery and some fun picks around the flowers.