Get out the Bowdabra and ribbons.

Cut all ribbons into 25” strips.

Dovetail all the ends of each ribbon.

Create a single 5” loop and twist so the pretty side is facing up for the tails.

Add it to the bow maker.

Repeat the previous steps with each strip of ribbon, alternating and making sure each layer goes in opposite directions from the previous layer.

Take a pipe cleaner and then wrap around the center of the bow.

Put the pipe cleaner in between the pointer and middle finger that is holding the bow, grab the pipe cleaner, and pull.

Start twisting the bow until it is nice and tight.

Fluff out the bow to your preference.