Prep your base
Twist Deco mesh into wreath base, make 10” to 12” poofs
Addition Deco mesh Cut 12 pieces at 25”
Fold mesh in 1”, then ruffle in the middle
Open twist tie and add on top of the deco mesh, twist back
Prep your sign
Glue ribbon to bottom of beehive covering the bottom, Optional: felt or foam board
Attach u pin to beehive straddling into beehiv
Attach beehive to wreath base at right bottom corner
Bow
Layer one: make 14” tail, twist and make 8” loops on each side x 2, cut ribbon tail at 14
Layer two: make 14” tail, pinch twist and make 8” loops x2, cut ribbon tail at 14”
Layer three: make 14” tail pinch twist and loop 8” x 2, cut ribbon at 14”
Layer four: make 14” tail, pinch twist and make smaller loops x2, cut ribbon tail at 14”
Layer five: make 14” tail, pinch twist and make smaller loops x2, cut ribbon tail at 14”
Zip tie big bow tight
Use chenille stems, twist around bow, take ever green tie and twist
Dove tail ribbon ends
Attach bee hive
Add 4" ribbon roller coaster tails x 3
Add 4" funky bow (no longer than 36") x 3
Prep florals
Cut floral and greenery stems
Add around wreath with dab of hot glue
Attach picks
Attach greenery around bow and around the wreath with a dab of hot glue
Attach daises with a dab of hot glue
(Optional) Attach white florals and additional picks with a dab of hot glue around the wreath