Using a thick dowel, mark at 5” down from the top
With the dowel, push completely through the center of the large styrofoam ball
Apply hot glue to the dowel and place into the large styrofoam ball
Push down to mark spot and through the other end; add glue to that end
Begin adding roses to top of ball with hot glue
Hold the roses down until they are bonded to the styrofoam ball
Continue adding roses until ball is fully covered
Make hole in the next size ball, add hot glue and add to top of first ball
Begin adding the roses to the smaller ball until completely covered
Make a hole in the styrofoam cone, mark where you want it to stop
Add glue to the hole and place on cone
Begin adding the roses to the bottom and continue until completely covered
Make two identical bows using 2-½” ribbon, make tails, two 9” loops and two 10” loops
Attach the first bow with zip tie and just before cinching, add second zip tie (leave open) and finish cinching, trim extra tie
Attach the second bow in the same manner with the zip ties
Attach both bows with one end of each of the zip ties, it will look like a U
Take the bows and add to the dowel and tighten the zip ties and trim the excess
Dovetail the ends
Add a rose in the middle of both bows
