Instructions: Pancake 14” frame
Prep Ribbon
Cut 12 strips of each ribbon at 14” for the outside ring
Cut 12 strips of each ribbon at 14” for the inside ring
Take one of each ribbon strips, place them on top of each, and fold in half
Prep your base
Insert pipe cleaners in the holes and where the inserts are and twist together
Cut 12, 20” strips of mesh
Ruffle the mesh starting straight up the center (1.0)
Twist into the wreath base on the outside of the wreath
Pinch the ribbon in the middle in an accordion type fold
Twist the ribbon into the wreath base on top of the mesh
Repeat the process for the inside of the wreath
Twist pipe cleanr to the back of the wreath base to create a hanger for the wreath
Prep Sign
Punch holes into the sign
Using 22 gauge wire, place into the holes of the sign
Attach sign to the wreath base
Bow
Layer one: make tail, pinch, twist and make 6” loops on each side, cut ribbon tail long
Layer two: make tail, pinch twist and make 6” loops x4, cut ribbon tail
Layer three: make tail, pinch twist and make 6” loops, one on each side cut ribbon tail
Layer four: make tail, pinch twist and make small middle loop, cut ribbon tail
Twist pipe cleaner around the bow tightly
Fluff bow
Tightly twist pipe cleaner around bow tight
Attach bow to wreath base