Start by wrapping a 6.5” round disk with felt using glue.
Trim off the excess felt.
Take a 4” round container and add a 4” ribbon around the edges using glue.
Take a 2.5” ribbon and add it around the edge of the container.
Add another 1.5” ribbon over the center of the 2.5” ribbon.
Add the bottom of the container to the disk using glue to make a top hat.
Add foam blocks inside the container using glue.
Add in some skewers to stabilize the foam blocks.
Take a 10” mesh and cut 6 x 10” pieces.
Take a 1.5 “ ribbon and cut 6 x 11” pieces
Dovetail the ends.
Take the mesh and fold in the edges and add your ribbon to it using a u-pin.
Add the mesh and ribbon to the foam block using the u-pin.
Repeat above instruction no. 13 - 14 for the remaining mesh and ribbon.