Prep your base
Cut Deco mesh in 22” to 24” strips x 24 times
Roll mesh about 1", then ruffle up the middle
Add ruffle in twist tie on the wreath base; twist twice
Once mesh has been added, squish in wreath base, use four 6” zip ties to secure base
Prep your sign
Staple pipe cleaners in the wooden sign, all 4 sides
Hot glue the back of the sign, attach to wreath base slightly above the middle of the wreath
Bow
Place rag bow below sign and attach to wreath base
Cut 4” ribbon and cut two pieces, twist to see both sides of ribbon and pinch
Attach to wreath base on each side of rag bow
Layer one: make 7” tail, twist and make 7” loop on each side (baby bow)
Layer two: cut 14” and place on top of layer one, attach to top right of wreath base
Layer one: make 7” tail, twist and make 7” loop on each side (2nd baby bow)
Layer two: cut 14” and place on top of layer one, position bow at top of wreath base
Cut 4” ribbon 14”, twist and pinch, attach to wreath
Trim tails as needed
Prep florals
Cut floral and greenery stems
Add around wreath with dab of hot glue
Position larger flowers around sign
Prep Attachments
Evenly position and attach firecrackers and stars