Peppermint Swag Mesh Recorded - Melissa
Equipment
- 32 inch Canadian Pine Swag C11920
- Green glitter sprays XS104906
- Chocolate dipped Marshmallows 84792SP20
- Glitter Mix Peppermint Cake Pop Pick
- Gingerbread Holy Spray 104564
- 10 inch leftover mesh
- 2 2.5 inch ribbons
- 1 1.5 inch ribbon
Instructions
Prep your base
- Start with a 32” Canadian Pine Swag
- Fluff out the pine needles.
- Add in a green glitter spray on each side of the swag using the pine needles.
- Take a 10” mesh and cut 7 x 20” pieces.
- Take the mesh and make cruffles by curling in the edges and pinching the middle together.
- Add the cruffles to the swag base using the pine needles.
- Add in a few smaller green glitter sprays to the center of the swag.
Add in your bundle sprays
- Take a gingerbread holly spray.
- Add in some chocolate dipped marshmallow spray.
- Secure the sprays with zip ties.
- Repeat above instruction no. 1-3 again.
- Add the sprays to each side of the swag using the pine needles.
- Add in some more green glitter sprays where needed.
Make and add your half bows
- Take 2 ribbons and make a half bow with 1 loop each.
- Layer the half bows.
- Secure your half bows with a zip tie.
- Add the half bow to the center of the swag using a pine needle.
- Dovetail the ends.
- Fluff out your half bow.
Make and add your bows
- Take 1 ribbon and make 2 bows with 2 loops each.
- Secure your bows with zip ties.
- Dovetail the ends.
- Add a bow to each side of the swag using the pine needles.
- Fluff out your bows.
- Take 1 ribbon and make 2 bows with 2 loops each again.
- Secure your bows with zip ties.
- Dovetail the ends.
- Add a bow to each side of the swag using the pine needles.
- Fluff out your bows.