Periwinkle Sunflower Wreath

The back of your grapevine wreath will be the flatter side.
Clean up the grapevine wreath using small clippers or sand paper to avoid any sharp edges.
Pull out any pine needles.
Determine where you'll be working your design in by pick the "ugly" less symmetrical section. Your florals should cover up those sections.

Stack your 2.5" white cabana stripe ribbon and 1.5" faux burlap ribbon and lay against your wreath base to decide the length of your ribbon tails.
Pinch at the desired the length and secure with a brown pipe cleaner.
Secure to the grapevine, clipping excess pipe cleaner.
Create a billow and secure the end to the grapevine with a brown pipe cleaner.
Leave a longer tail between 15"-17"
Curl up the longer tails.

Start with the 2" ribbon. Start with about an 7"-8" tail.
Create a 7"-8" loop, adjust as need for your wreath.
Create a 2nd loop of the same size, give the ribbon a pinch and twist.
Create a 3rd loop of the same size, leaving a slightly longer tail around 10"
You can use bow making tool to hold your different bow layers.
With your 1.5" faux burlap ribbon start with 7" tail and create a 5" loop pinch then twist.
Create a 2nd loop of the same size, give the ribbon a pinch and twist.
Create a 3rd loop of the same size, leaving a slightly longer tail around 10"
Add your bow to the bow maker to hold, keeping the side with 2 loops opposite of the 2 loops from the previous bow.
Next, with the 1.5" white cabana stripe ribbon, start with about an 10" tail.
Create a 4" loop, pinch and twist.
Leave a slightly shorter tail.
Insert into bow maker
Secure all the layers together with a pipe cleaner.
Secure the first bow at the top of your billow with a zip tie.
Dove tail tails.
Fluff out bow.

Start with the 2" ribbon. Start with about an 6"-7" tail.
Create a 4"-5" loop, adjust as need for your wreath.
Create a 2nd loop of the same size, give the ribbon a pinch and twist.
Create a 3rd loop of the same size, leaving a slightly longer tail around 10"
With your 1.5" faux burlap ribbon start with 10"-12" tail and create a 3"-4" loop pinch then twist.
Create a 2nd loop of the same size, give the ribbon a pinch and twist.
Create a 3rd loop of the same size, leaving a slightly longer tail around 10"
Next, with the 1.5" white cabana stripe ribbon, start with about an 5-6" tail.
Create a 2" loop and 5-6" tail.
Next, with the 1.5" white cabana stripe ribbon, start with about an 10" tail.
Secure with a pipe cleaner.
Secure the second bow at the bottom of your billow with a zip tie.
Dove tail tails.
Fluff out bow.

Start with the lamb's ear, cut down stems.
Bend stems slightly so they go into the grapevine following the natural curve of the wreath base.
Add stems opposite sides of each bow, and work in additional lamb's ear stems.
Hot glue stems in place.
Incorporate stems into bow.
Add pops of color using lavender stems or any other colored stems.
Hot glue into place as you move along.
Bend stems so blend together naturally.
Incorporate filler flowers and add periwinkle sunflowers as your main flowers.
Give your design a skim and fill in as needed with greenery or floral stems.
Fluff out bows.