Starting with a pumpkin shaped board and add a square piece of styrofoam in center with hot glue
Using a greenery bush cut stems off into smaller pieces, cut at angle
Place one in each of the sides of the styrofoam, place one in the top center, near the back
Prep two pumpkins, make a hole on the side you want to attach to the base and add hot glue and nub or skewer
Add one of the pumpkins to the center of the base
Add some pieces of grasses, cut stem at angle, separate into smaller pieces
Cut at angles and add pieces into corners with hot glue
Bring the next layer of grasses up higher and working some pieces under the first layer
Next use a mixed greenery bush, cut 5 stems off at an angle, fluff them
Add to empty holes at varying heights
Add stem to the second pumpkin with hot glue, make another hole in the first pumpkin where the second one will be attached.
Make a bow with a 2-1/2” ribbon,2 tails at 8”, 2 loops at 6”, tie off with pipe cleaner
Using a u-pin, add under the pipe cleaner and wrap around each side, add hot glue
Add bow to base, fluff out loops and tails, cut tails at an angle
Add a ribbon tails to the back of the centerpiece, where there might be holes, working in a triangle; cut tails at an angle
Using the filler bush, cut pieces off, add in empty spaces
Continue to add pieces of the filler bush, remembering to add in a triangle and filling in any empty spaces
Using a floral spray, cut off blooms, add three blooms with hot glue
Add a small pumpkin in the same manner as the others