Using a lighted jack-o-lantern,
Using a 10” patented pancake wreath base, add 6 pipe cleaners
Cut six 20” strips of 10” deco mesh and make ruffles
Lay ruffles horizontally into the pipe cleaners
Cut a 3” circle in the center of a styrofoam disk
Place the disk on top of the jack-o-lantern with hot glue
Place the wreath base with the ruffles on top of the jack-o-lantern
Add one of the floral stems, cut the stem, add near the rear center of pumpkin stem, fluff out
Determine where to place the bow
Using 2-½” ribbon, make a 7” tail, pinch, twist, 6” loop, x4, 7” tail, tie with pipe cleaner, dovetail ends
Use 1-½” ribbon, 7” tail, pinch, twist, 6” loop x3, 7” tail, dovetail ends, layer on top of previous loops
Use another 1-½” ribbon, 7” tail, pinch, twist, 5-½”loop x2, 7” tail, dovetail ends; layer on top of previous layers, tie with pipe cleaner
Attach bow to the pancake wreath base
Prep florals by cutting off the stems
Begin filling in with other florals in between the mesh into the pipe cleaners and into the styrofoam at an angle, hot glue
Trim the next 2 floral pick stems, add one next to the center floral, the other on the opposite side, hot glue and fluff
Continue with some of the filler florals into the foam, hot glue
Take the next floral spray just behind the center floral piece, spread out, hot glue in
Trim the next pick and hot glue into the center front (in between the two floral picks)
Trim off the various other picks, sprays, greenery and continue adding them to empty spaces with hot glue
Optional: make some funky bows by cutting 22” of 1-½” ribbon
Fold in half, pinch half was down, flip one of the tails to front, place in one of the pipe cleaners in the ruffles
Repeat & make 2 more funky bows; place in every other ruffle