Stretch out and fluff the garland
Add the floral garland on top of the evergreen garland close to the spine
Attach with the pine tine in between the pick clusters
Determine the placement of each pick clusters, pull them up
Make a 3 loop bow and tuck into the garland
Using 1-½” ribbon make a 12” tail, 9” loops (18 inches from the pinch); make 2 loops
Repeat step 6 for next layer, make a little smaller than the first layer, tie into the garland
Repeat step 6 again with another 1-½” and 2-½” ribbons; 12” tails, 9” loop; make 2 loops
As you add the bows, spread them out and work the florals in and round the bow
Make two more bow exactly like the first two
Place a full floral stem into each of the bows and fluff around the bows
Dovetail all ribbons
Layer another floral garland on top using the pine tines
Go through and fluff each bow and florals
A Bonus Tip
Using some of the left over floral picks and garland
Take a small piece of garland
Layer pieces of the stems and tie with pine tines; Fluff out
Make a bow with a long tail and two 7” loops using all the ribbons
Each layer the loops should be slightly smaller; the final ribbon should be a one loop bow
Attach all layers together with pipe cleaners
Add bow to the center of garland with pine tines
Dovetail the ends
Can be used as a lantern swag
