Prep your base
Combine two 36” garland bases and zip tie together
Fluff out your garland base and place the pine needle flat for each side of the base
Using 10” mesh, gather together all at once the ends of the mesh making a baby loop with the end
Twist into the end of the garland base with the pine ties
Make 12” humps by bunching up the mesh and twist down the garland with even humps
Cut excess mesh
Cut 10” mesh into 10 to 15” strips using the rest of the 10” mesh
Ruffle the mesh strips and twist into the garland base right in the middle of the garland
After the ball garland is attached, Cut 25” to 30” strips of green and white mesh
Ruffle the mesh and attach to the garland base
Trim the pine needle in the middle top and bottom of the garland where it was connected together
Prep the sign attachments
Hot glue mount to the back of the sign
Insert pipe cleaner into the mount and attach to the middle of the garland base
The second set of signs, peak in the signs into the base. Add a dab of hot glue
Bow
Cut 36” of ribbon and fold it in half, making a 7” loop and twist ribbon
Attach the funky bows to the garland base
Dove tail the ribbon ends
Ribbon two: Make a clover bow. Pinch, twist loop 4X, Loops and 6 ½ “
Make second clover bow
Attach bows to the garland base
Ribbon three: Make a 12” roller coaster and twist into the garland base on each side
Dove tail the ribbon ends
Add shoe lace bow on top of the bows on each side of the sign, dove tail the ends
Prep florals, picks and attachments
Split ball garland and cut off the red of the garland
Attach ball garland to the garland base by twisting in with the pine needles
Attach the final ball attachments to the base about one every foot with a dab of hot glue
