Go Back
Print

Tammy Mesh Wreath

Materials

  • 1 unit wreath form
  • 1 roll 21 inch mesh
  • 2 rolls Black and White Mesh
  • 2 rolls two separate ribbons
  • 2 rolls 1.5 inch ribbon
  • 1 unit sign
  • 1-2 bunches Pink and Purple Flower fillers
  • 1 bunch Add Greenery

Instructions

Prep your work wreath form

  • Spread out your pine tines and get them all separated

Add mesh to wreath form

  • Using 21 inch mesh drop it to the floor, gather it together and then measure it out 14 inches and fold it over to make a poof. Then lay it down in pine tine and twist and secure it.
  • Working counter clockwise keep repeating adding your poofs working your way all the way around. No need to measure just make sure they are all equal size.
  • Once you do your final loop on that ring open back the tie you started with lay the end of your mesh down. Then clean it up with scissors if you need to
  • To make your outside poofs do the same steps as above but make them about an inch bigger. Start fanning them as you attach them.

Add Black and White Mesh

  • Cut strips into 20 inches in length you will need 18
  • Then make basic ruffles and attach to wreath form. Working your way around the inside ring then work your way around the outside ring.

Cut and Add Ribbon Tails

  • Cut 9 tails at 14 inches each of two separate ribbons
  • Dovetail each end
  • Then add your ribbon tails by layering them on top of each other. Attach them every other one. Fold them in half like a bow tie, lay it in there and lay flat, secure with twist tie and keep adding.

Add Funky Tail

  • Cut 26 inches, fold it half, cut a v cut. Come down 4 inches and fluff the hair out, ring her neck, kick her leg out and twist her booty out!
  • Repeat and add toevery other one.

Make Bow

  • Measure out 18-20 inch tails, Pinch it, twist, and make a loop. Make an 8 inch loop and repeat the same thing on the left side. Make sure your loops are equal. Then pinch and twist to continue making loops.
  • Add in your next ribbon make a shorter tail, make a bit smaller loop about 6 inches. Pinch twist loop. Just making two loops with that ribbon.
  • With your third ribbon make your tail, and repeat the same steps as above but make your loops a bit smaller.
  • With your 1.5 inch ribbon repeat the same steps just make your loops and secure with a pipe cleaner. Twist it and then twist it bow. Fluff your bow and attach at the 7 o'clock position

Attach Sign

  • Hide your rope of sign with the ribbon. Placing a pipe cleaner around the rope to secure it.

Add Pink and Purple Flower fillers

  • Place them behind the house sign by adding hot glue to stem before placing. Then spread out the florals. Work them around your work alternating the colors.

Add Greenery

  • Leave stems on for depth. Placing hot glue on the end start adding in-between your flowers and just add all around your mesh.