Winter Wreath - The Makers University

Go Back

Smaller Normal Larger

Print

Winter Wreath

Instructions

Prep wreath

Push wreath together to make it more of and oval
Fluff your spindles by pulling them out all the way around

Add mesh

Using 10 inch mesh go all the way around the outside mesh
Making each pouf about 8 inches, all the way around.

Add mesh ruffles

Using blue 10 inch mesh gather together and secure with spindles.
Add them on the outside of the wreath

Add Ribbon Tails

Using 2 2.5 inch ribbons, Alternate which ribbon is on top.
Place each set of ribbons on the inside. Gather together in the middle and secure with the spindels

Make and Add Bow

With your first ribbon (snowman) make four loops and cut tail at about 18 inches
With second ribbon (red and white) make four loops as well holding tight in the center. Cut tail.
Adding in a blue ribbon now making only two loops. Cut tail
Now using 1.5 inch ribbon make three loops and secure with a zip tie.
Secure bow with zip tie, fluff your loops,

Attach sign

Thred zip tie to the back of wreath and attach to the inside bar. This helps it stay nice and secure.

Add Ornaments

Using hot glue place hot glue right on top of ornmanet ball and add directly to mesh of wreath.
Always do ornaments in sets of three

Add sucker pick

Add a small mini bow to the bottom of your sucker
Place pick right in top left, using hot glue